| Customization: | Available |
|---|---|
| Application: | Electronic |
| Type: | Current Transformer |
|
Still deciding? Get samples of US$ 168/Piece
Request Sample
|
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
he round jaw design on the P18 series double ratio AC current clamp along with the high content permalloy core makes them well suited for power quality applications where high accuracy and low phase shift along with wide frequency are important. Measurement range is 1mA to 200A.
The P18 AC current clamp is a general purpose 200A AC current clamp ct designed for use with DMMs, power loggers and energy meter calibration instruments that have a current input. It has a 1000:1 ratio and output of 1mA per amp or 1mV per amp measured in the jaw. The P18 clamp ct has an integral 2.5m lead terminated. The rounded jaw design on this current clamp makes it well-suited for power applications where high accuracy 0.1% and low phase shift and wide frequency response are important.
UL, CE mark;
Holding wire diameter: φ18mm;
Frequency 10Hz-2MHz bandwidth;
High times harmonic measurement;
Conforms to EN 61010, 600V CAT III;
Measurement range of 1mA to 200A AC;
Low phase shift for power measurement;
High content nickel metal permalloy core;
Improved ergonomic design & easy operation;
High precision 0.1% for current measurement;
Designed for DMMs, recorders, loggers, oscilloscopes, power and harmonic meters;
| Ratio | 1000:1 or 2000:1 (customized) |
| Accuracy class | 0.1%, 0.2% |
| Primary current | 0-10A AC and 0-200A AC |
| Signal output | 10A (100mV/A) and 100A (200A)(10mV/A) with switch |
| Secondary voltage | 0-1V AC, 0-2V AC, 0-5V AC, 0-10V AC |
| Secondary current | 0-100mA AC and 0-200mA AC |
| Max. Cont. Input current | 240A |
| Load capacity | ≤20Ω, standard 4Ω |
| Over voltage category | CAT III 600V |
| Frequency range | 10Hz-2MHz |
| Dielectric strength | 3KV 50Hz/60Hz at 1minute |
| Temperature range | -40°C to +55°C |
| Output | 2.5 meter cable with D01 or BNC connector, 4mm banana |
| Max. voltage not insulated conductors | 600V |
| Ratio | single winding, or double winding |
| Standard | EN 61010-1, EN 61010-2-032, EN 61010-2-031 IEC60044-1, & IEC61869-2, 600V CAT III |
| Installation | Clamp type |
| Output mode | Lead output (2.5m) |
| Connector | BNC, 4mm banana, signal cable (2 cores), customized |
){kind=link}