| Customization: | Available |
|---|---|
| Type: | Electromagnetic |
| Output Signal Type: | Digital Output |
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
The S50 clamp on CT has an integral 2.5m lead terminated. The rounded jaw design on this current clamp makes it well-suited for power applications where high accuracy 0.1% and low phase shift and wide frequency response are important.
Phase angle meter;
Energy sub-meters;
Cable fault analysis;
Power load monitoring;
Large industrial loads;
Data logging/recording;
Energy meter calibrator;
Earth resistance meter;
Power quality monitoring;
power and harmonic meters;
Power quality analyzer (PQA);
| Electrical parameters | |
|---|---|
| Ratio | 1000:1, 2000:1, 1000:5 (customized) |
| Accuracy class | 0.1%, 0.2%, 0.5% |
| Primary current | 0-500A AC and 0-1000A AC |
| Signal output | 1mV/A, 1mA/A |
| Secondary voltage | 0-0.5V AC and 0-1V AC; |
| Secondary current | 0-1A or 0-5A AC |
| Max. Cont. Input current | 1200A |
| Load capacity | ≤20Ω, standard 4Ω |
| Over voltage category | CAT III 600V |
| Frequency range | 10Hz-10MHz |
| Dielectric strength | 3KV 50Hz/60Hz at 1minute |
| Temperature range | -40°C to +55°C |
| Output | 2.5 meter cable with D01 or BNC connector |
| Max. voltage not insulated conductors | 600V |
| Standard | EN 61010-1, EN 61010-2-032, EN 61010-2-031 IEC60044-1, & IEC61869-2, 600V CAT III |
| Installation | Clamp type |
| Range | 10A, 100A, 1000A optional |
| Output mode | Lead output (2.5m) |
| Connector | BNC, 4mm banana, signal cable (2 cores), customized |
| Accuracy (1000A range) | |
| 0-10A | ≤0.5% |
| 10-100 | ≤0.2% |
| 10-1200A | ≤0.1% |
| Phase shift (1000A range) | |
| 0-10A | ≤0.5° |
| 10-100 | ≤0.2° |
| 10-1200A | ≤0.1° |
| Mechanical parameters | |
| Dimensions (L x W x H)(mm) | 105 x 218 x 30 |
| Weight (g) | 650 |
| Holding wire diameter (mm) | φ52 |
| Max. jaw opening (mm) | 52 |
| Jaw color | Red & grey |
| Material | PC+ABS, UL94 V0 |
){kind=link}