P18 200A Double Ratio Voltage Output AC Current Clamp on CT

Product Description

P18 200A EN61010 600V CAT III low phase shift for power measurement

Product Description

The round jaw design on the P18 series double ratio AC current clamp along with the high content permalloy core makes them well suited for power quality applications where high accuracy and low phase shift along with wide frequency are important. Measurement range is 1mA to 200A.
The P18 AC current clamp is a general purpose 200A AC current clamp ct designed for use with DMMs, power loggers and energy meter calibration instruments that have a current input. It has a 1000:1 ratio and output of 1mA per amp or 1mV per amp measured in the jaw. The P18 clamp ct has an integral 2.5m lead terminated. The rounded jaw design on this current clamp makes it well-suited for power applications where high accuracy 0.1% and low phase shift and wide frequency response are important.

Product Parameters

Electrical parameters
Ratio	1000:1 or 2000:1 (customized)
Accuracy class	0.1%, 0.2%
Primary current	0-10A AC and 0-200A AC
Signal output	10A (100mV/A) and 100A (200A)(10mV/A) with switch
Secondary voltage	0-1V AC, 0-2V AC, 0-5V AC, 0-10V AC
Secondary current	0-100mA AC and 0-200mA AC
Max. Cont. Input current	240A
Load capacity	≤20Ω, standard 4Ω
Over voltage category	CAT III 600V
Frequency range	10Hz-2MHz
Dielectric strength	3KV 50Hz/60Hz at 1minute
Temperature range	-40°C to +55°C
Output	2.5 meter cable with D01 or BNC connector, 4mm banana
Max. voltage not insulated conductors	600V
Ratio	single winding, or double winding
Standard	EN 61010-1, EN 61010-2-032, EN 61010-2-031 IEC60044-1, & IEC61869-2, 600V CAT III
Installation	Clamp type
Output mode	Lead output (2.5m)
Connector	BNC, 4mm banana, signal cable (2 cores), customized
Mechanical parameters
Dimensions (L x W x H)(mm)	52.5 x 137.5 x 28
Weight (g)	400
Holding wire diameter (mm)	φ18
Max. jaw opening (mm)	18
Jaw color	Red, black
Material	PC+ABS, UL94 V0

Functions and Features

P18 features:
UL, CE mark;
Holding wire diameter: φ18mm;
Frequency 10Hz-2MHz bandwidth;
High times harmonic measurement;
Conforms to EN 61010, 600V CAT III;
Measurement range of 1mA to 200A AC;
Low phase shift for power measurement;
High content nickel metal permalloy core;
Improved ergonomic design & easy operation;
High precision 0.1% for current measurement;
Designed for DMMs, recorders, loggers, oscilloscopes, power and harmonic meters;

P18 application:
Multimeter;
Power meter;
Phase angle meter;
Energy sub-meters;
Power load monitoring;
Data logging/recording;
Energy meter calibrator;
power and harmonic meters;
Power quality analyzer (PQA);
Measuring around cable bundles;
Waveform analysis (oscilloscopes meter);